Why am I unable to set up tracking force?ġ.30101. What can I do if the cartridge is sliding outwards?ġ.20502. Can I use only one counterweight?ġ.20501. How important is the level of damping oil?ġ.20202. Can I mount Stogi S on all turntables?ġ.20201. Why does Stogi S not have an armrest?ġ.20102. There is sometimes difficult to rotate the counterweights from early Stogi models. How can I test the bearings on Stogi & Stogi Ref tonearms?ġ.10501. Do the ball bearings in any Stogi tonearms need lubrication after years of use?ġ.10302. Can I use the VTA system from Stogi Ref 313 VTA on standard Stogi arms?ġ.10301. How does the VTA kit for Stogi and Stogi Ref tonearms work?ġ.10104. What are the main differences between the Stogi and Stogi Ref arms?ġ.10103. What are the differences between the Stogi arm produced in 1985 and those produced after 1994?ġ.10102. The bias force is too strong and pulls the tonearm outwards while I am lowering the arm into the groove?ġ.10101. Everything appears to be OK, but one wire is apparently broken to an ohm meter.ġ.00502. Why do some Kuzma tonearms not have finger lifts?ġ.00501. How important is horizontal levelling of the tonearm?ġ.00402. How do I connect cartridge pins to the cartridge without damaging the wire?ġ.00208. How important is Vertical Tracking Angle (VTA)?ġ.00206.

How can I set up the bias precisely?ġ.00204. What is optimal tangential geometry?ġ.00203. How much does azimuth angle change with a full 360 degree rotation of the azimuth screw?ġ.00202. Where are the serial numbers on the tonearms?ġ.00111. What is the capacitance of tonearm cables?ġ.00110. What are the effective lengths and mounting distances for various tonearms?ġ.00109. Which oil is used for tonearm damping?ġ.00108. Why do 12 inch tonearms appear to perform better then 9 inch ones?ġ.00107.

Does damping alter tonearm resonance?ġ.00106. Where is optimal tonearm resonance?ġ.00105. What cartridge parameters are important for matching cartridges with tonearms?ġ.00104. Is it possible to make a Kuzma tonearm pre-cut on a non Kuzma turntable’s armboard ?ġ.00103. What cut-outs are used for mounting Kuzma tonearms?ġ.00102.

Tonearm rewiring service